Ktm 950 SMR Installation and Removal Manual
download Be sure the triple clamp in your kit has a part # 3012R- 27 -6-0208 on the bottom side. This is very important. 2. Warning: Once the triple clamp is loose, the forks can roll away from the...
View ArticleTOYOTA E ECU / COLD START INJECTOR TIME SWITCH MODIFICATION
download Before replacing an ECU or a cold start injector time switch, perform a thorough inspection to verify that all engine mechanical, fuel and electrical/electronic systems are to recommended...
View ArticleSuzuki GSX1400FE CHASSIS REMOVAL AND INSTALLATION
download REMOVAL SEAT Remove the seat with the ignition key. FRAM COVERS Remove the seat. (*Above) Remove the frame cover mounting secrews (left and right sides). Remove the frame covers by pulling...
View ArticleSuzuki B-King GSX1300 BK Suspension Removal and Installation
download Front Fork Removal and Installation B823H12206002 NOTE The right and left front forks are installed symmetrically and therefore the removal procedure for one side is the same as that for the...
View ArticleDucati 1098 and 1098S ECU connection Installation Manual
download ECU can be connected to AIM loggers in two different ways: directly, or using the connector placed on the dashboard. 2.1. – Direct connection between AIM loggers and Marelli IAW 5AM2 ECU IAW...
View Article2001-2003 XV16 Fuel Pump and Carburetor Removal
download Disconnect the carburetor fuel line hose at the fuel pump. •Disconnect the fuel pump wire coupler. •Remove the choke cable from fuel pump bracket. •Remove the upper engine mount, leaving the...
View ArticleYAMAHA V-Star 1100 Carburetor Bowl Screw Repair and Removal After Stripping...
download When I first started working on bike many years ago, I learned the danger of stripping the heads of Philips screws when removing or installing them on motorcycles. I remember the two worst...
View ArticleYAMAHA ROADLINER / STRATOLINER REMOVAL AND INSTALLATION MANUAL
download 1. Cover the right frame tube in front of the exhaust with duct tape or any suitable material to protect frame during exhaust removal. 2. Remove the three capscrews holding the muffl er...
View Article2001 – 2003 Prius 2003 4Runner, Camry, Land Cruiser and Sequoia VEHICLES...
download When replacing the ECM (SAE term: PCM) or the Transponder ECU a “handshake” procedure must be performed. This ECU ID communication is necessary to enable the Transponder ECU and the ECM to...
View ArticleHonda CBR F4 or F4I 600cc Engine PE-ECU-1 System INSTALLATION
download The PE-ECU-1 can be installed on virtually any 1,2,4,6 or 8 cylinder even-firing engine that requires fuel injection and/or ignition control. All of the functions of the ECU can be adjusted by...
View Article